It's time to consider replacing the button cable on the iPhone 7. To do this, you need to have patience and a quality tool. The plume of buttons is responsible for the following parameters:
- volume control;
- power management;
- microphone;
- flash with double LEDs;
To replace the loop of buttons you need to open the phone, know the motherboard, Taptic-engine, battery. This may damage the moisture resistance of the display sizing. If this sizing is not replaced, your iPhone will lose moisture resistance, but will work properly. You need to turn off your device before you start. Unscrew the two star screws located on the bottom of the housing. To remove the module, it is necessary to heat it so that the adhesive tape responsible for moisture resistance is easier to remove and we can easily disconnect the module.
Install the suction cup on the screen and pull with such effort that there is a small gap between the body and the display where we push the plastic pickup. With this mediator, we run along the screen to remove the sizing around the perimeter. Open the iPhone on the left side and unscrew the 6 screws that hold the two. We carry out dismantling of these laths by means of tweezers. We use a mediator to disconnect the loops, the first to disconnect the battery cable. So we disconnected the screen module from the case. The next step is to remove the SIM card. The flat end of the mediator disconnects the main camera loop. Unscrew the two screws that hold the bar of the upper loop and the two screws that hold the metal bar of the main chamber, then remove the camera. Our next step is to unscrew the four screws that hold the WI-FI antenna. Then remove the antenna and unscrew the two screws that secure the bracket. Use the narrow part of the mediator to disconnect the connectors of the two antenna cables, which are located at the bottom of the board.
To disassemble the motherboard, we need to unscrew the four screws and bend the SIM card release lever from the motherboard. After such actions, the board should be easily dismantled, if you hear resistance, make sure you unscrew everything. In order to remove the battery we will need to remove the pressure compensator and Taptic-engine. So remove the pressure compensator from the back of the case. Unscrew the three screws holding the Taptic engine and remove it. Now nothing prevents us from removing the battery. The battery should be handled with the utmost care, not to climb into it with sharp objects, so as not to damage it. To do this, bend the adhesive strips on the bottom of the battery with the blunt ends of the tweezers and pull on yourself. You need to pull with a little effort and evenly so as not to break it. If everything is done correctly, there should be no problems. Remove the battery from the back of the case. Unscrew the five Phillips screws that hold the button cable. Starting from the power button, move the pickup to know the adhesive tape that holds the plume of the light sensor on the back of the case. You can also heat the case or drip a little alcohol, which also makes the process easier to remove the loop of buttons. Unscrew the locking screw that secures the flash bracket to the back of the case. Carefully lift the flash module with the sharp side of the pickup. Also on this side of the mediator we try to separate the glue that attaches the microphone to the back of the case. Our main task is to insert the blade under the power button and lead to the end of the loop of buttons to separate the adhesive tape. Using tweezers, remove the train of buttons. You can assemble the device thanks to this instruction, only in reverse order.
Reviews about Replacement volume buttons on the iPhone 7
0 Message text