iPhone 6: price and instructions for replacing the case
It would seem that damage to the iPhone 6 case is only a problem of aesthetics. This is true only if there are no significant scratches or dents on your body. But if there is enough significant damage to the case? For better ergonomics, Apple has made the iPhone 6 with a fairly thin body, and there is no free space under the cover. All elements are located close to each other and to the case including. Users often buy Apple smartphones to stay stylish. But it's hard to be proud and stay stylish with a smartphone that looks downright bad. Therefore, users often replace the case in the iPhone 6. Before replacing, you need to turn off the phone.
For a trouble-free repair process you need to have:
- Pentalobe 0.8 screwdrivers;
- Philips 1.5 screwdriver;
- Mediator blade;
- Suction cup;
- Tweezers;
- New building.
After the phone is turned off, unscrew the two lower bolts that hold the display frame. Carefully open the phone by lifting the display module up with a suction cup or a special spatula.
To disconnect the display module, you must first de-energize the board by removing the protective strip above the battery connector and disconnecting it. Next, remove the protective bar from the module connector and disconnect the module and all attachments.
Next, we disconnect the two loops of the volume and vibration buttons and the power button. After that, we dismantle antennas and amplifiers. Next, remove the main camera, before that, removing the protective bar. After removing the camera, remove the seven-tray, then unscrew the three screws that hold the motherboard and remove it.
Disassembly of the battery will be a little easier and more convenient if we remove the vibratory motor Taptic Engine and speaker, and then dismantle the battery by pulling the special ends of the tape, which are at the bottom of the battery. When replacing the case in the Apple iPhone 6, you can replace your battery with a new one if you have:
- Maximum battery capacity is less than 75%;
- The battery is inflated or damaged along with the iPhone 6 case;
- The battery discharges quickly or does not charge.
To remove the loops of the buttons, unscrew the screws at the mounting points and carefully remove them, it is desirable to heat them so that the glue to which they are attached - became a little softer and lost its properties. After all the above actions, dismantle the lower loop, pre-unscrewing all the screws to which it is attached. Also, before installing the lower screens, the speakers and microphone should be cleaned with alcohol and a toothbrush or replaced if:
- You are hard of hearing to the interlocutor;
- Your main speaker starts to squeak at high volume;
- If there are large holes in the mesh.
In order to install all the parts in the new iPhone 6, all the steps must be performed in reverse order. Before you close the phone, you need to test it, and only after making sure that everything works properly you can close the phone. Of course, it is difficult to repair the case in the iPhone 6 on your own, in addition, you can damage any other related elements, break the cables or break the motherboard, so we recommend that you contact specialists who professionally and efficiently perform the entire repair process.
Reviews about Replacement shell iPhone 6
0 Message text